study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course
study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

مشاركة

Share on facebook
Share on linkedin
Share on twitter
Share on email

study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

 

تأليف: shafik jendia(مشرف):: usama a.m. tabash(اعداد)
اللغة: إنجليزي
النشر: gaza strip:islamic university of gaza 2013
المكان: خانيونس-مكتبة الجنوب المركزية-مجموعات خاصة/خـانيونس
النوع: رسائل جامعية
عدد الصفحات: 121
المواضيع: asphalt – engineering materials:: الخرسانة الاسفلتية
رقم التصنيف: 620.196
الرقم العام: 1342047

العنوان : study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course
study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

 

ABSTRACT

Various solid wastes that are emerged from steel plants are blast furnace slag, blast furnace flue dust, sludge and mill particle.

Therefore, use of waste materials in road pavements is nowadays considered not only as a positive option in terms of sustainability, but also as an effective option in means of providing enhanced performance in service.
This is especially true in the case of reuse of waste iron. In this research, a number of aggregate tests are conducted which are: sieve analysis, specific gravity, absorption, abrasion, adsorption and scanning electron microscope.

These tests are to investigate the applicability of using the waste iron powder (WIP) as an asphalt binder in road pavements. Moreover, as a comparison, the same tests were applied on the conventional aggregates.

Furthermore, number of bitumen tests is conducted. They are penetration test, softening point, ductility, flash point and specific gravity. Marshal samples are prepared using both conventional blending aggregates and (WIP) to investigate the properties of the asphalt mix: stability, flow, bulk density and comparing the results with the specifications. WIP were introduced in the asphalt mixture in grinded form 0 – 2.00 mm.

Marshal mix design procedure was used, first to determine the Optimum Bitumen Content (OBC) and then further to test the modified mixture properties. In total, (58) samples were prepared, 30 samples were used to determine the OBC for two stages and the remaining were used to investigate the effects adding different WIP percentages to asphalt mix. At the first stage, the OBC was 5 % by weight of asphalt mix.

Moreover, at the first stage, the ratio of sand was 5% from weight of aggregate, Four proportions of WIP by weight of aggregates were tested 1.25, 2.5, 3.75, and 5%.
Besides, testing of ordinary asphalt mix. The results showed that it is possible to use the WIP in preparing the asphalt binder course. WIP content of 5 % by weight of aggregate for asphalt mix is recommended as the optimum WIP content for the improvement of performance of asphalt mix.
Asphalt mix modified with this percentage has approximately 23% higher stability value compared to the conventional asphalt mix.

The second stage is done to ensure the results that appeared at first stage by increase the ratio of WIP 7.5 and 10%. Asphalt mix modified with higher percentages of WIP shows higher bulk density, higher flow and higher air voids.

study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course
study the effect of crushed waste iron powder as coarse sand and filler in the asphalt binder course

 

 

Loader Loading...
EAD Logo Taking too long?

Reload Reload document
| Open Open in new tab

تحميل [1.18 MB]

طالع أيضا

المصدر 

اشترك في النشرة الإخبارية لدينا

احصل على التحديثات وتعلم من الأفضل

طالع المزيد

الدراسة الطولية
إعداد البحث العلمي

الدراسة الطولية (Longitudinal Study) | التعريف والمنهج والأمثلة

في الدراسة الطولية، يقوم الباحثون بفحص نفس الأفراد بشكل متكرر لاكتشاف أي تغييرات قد تحدث خلال فترة من الزمن.   فهرس المحتويات1 مقدمة2 ما هي المدة الزمنية الكافية لإنجاز الدراسة الطولية؟3 الفرق بين الدراسة الطولية والدراسة المقطعية أو المستعرضة3.1 مثال (1)4 كيفية إجراء الدراسة الطولية5 جمع البيانات من أجل الدراسة الطولية5.1 مثال (2)6 مزايا وعيوب

كيفية اعداد دراسة حالة
إعداد البحث العلمي

كيفية اعداد دراسة حالة: 4 خطوات رئيسية

دراسة الحالة هي دراسة مفصلة لموضوع معين، مثل شخص أو مجموعة أشخاص أو مكان أو حدث أو منظمة أو ظاهرة. تُستخدم دراسات الحالة بشكل شائع في البحوث الاجتماعية والتعليمية والسريرية والتجارية. ونناقش في هذا المقال كيفية اعداد دراسة حالة.   فهرس المحتويات1 مقدمة2 متى يجب القيام بدراسة حالة؟3 خصائص دراسة الحالة الجيدة4 أمثلة على دراسة

يسعدنا ان نقدم لكم خدماتنا

تواصل معنا

small_c_popup.png

تواصل معنا لتعرف أكثر
حول تحكيم ونشر الأبحاث وجميع خدماتنا اللغوية والبحثية

يسعدكم افادتكم بكل ما تودون معرفته